The micro rotor automatic positioning and balancing machine can balance micro motor rotors with a weight of up to 5 kilograms and a diameter of 260mm, which is easy to operate. It adopts a servo drive device to achieve stepless speed regulation of parameters and can smoothly accelerate and decelerate. The Shenman fully automatic balancing machine is driven by a servo motor and can operate at any angle and speed. It can operate continuously in the same direction at 360 degrees, without the need for reciprocating motion, reducing movement movements and improving component life.

Huake Zhichuang Micro Rotor Automatic Positioning and Balancing Machine
1、 Verification requirements
The unbalanced mass applied to the left and right straightening surfaces of the dynamic balancing machine should correspond to the phase value indicated on the power box display screen, and the position should not exceed ± 3 °.
2. The unbalanced mass applied to the left and right calibration surfaces of the dynamic balancing machine should correspond to the mass displayed on the test display screen, and the error should not exceed 2%.
2、 Verification method
1. Before use, clean the workpiece, especially the diameter of the rotor shaft, rollers, universal joints, and universal joints.
2. Adjust the distance between the two guide rails to fit the distance between the bearings on both ends of the standard rotor. After tightening the screws for the impact control of the universal joint, place the standard rotor on the dynamic balancing machine
On the two guide rails and connected together to prevent axial displacement of the universal joint rotor.
3. After connecting the main power supply of the dynamic balancing machine, power up the meter box. After opening the electrical measurement box, its model and version number will be displayed, and then the measurement box will automatically enter the self check process according to the program.
After completion, the 'TEST' symbol will be displayed. If the internal operation of the electrical measurement box is normal and the connection between components is interrupted, the measurement box will enter the measurement process, otherwise the display will remain unchanged
Hold in the "TEsTE" position.
4. In the initial situation, the content of the storage unit is displayed on the display screen: A: B: c, R1, R2 values, correction method, stress, multiplication, and file number. If the standard number of rotors is changed
If stored in a storage file, the file will be called and the measurement button will be pressed to enter the measurement process. If the standard rotor data is not stored in the storage file, the rotor standard must be entered
Data, then input the measurement process and click 'Reload' for measurement.
After completing the above correction, press the start button to rotate the rotor. The rotor time will be displayed in the measurement box. After multiple measurements in the memory, the measurement results will be automatically stored and reset.
Record the measurement results. The magnitude and phase of the imbalance must comply with (1) and (2).
6. Apply an unbalanced mass of 2.5 g, 5 g, and 10 g on the left side of the adjustment surface, check whether the instrument is correct, and whether the display of the inner box corresponds to the actual mass and quality stage.
7. Apply unbalanced mass on the correct correction surface, measure and monitor whether the values displayed on the electrical box of the fully automatic balancing machine correspond to the phase and mass of the actual weight mass, and
Correct accordingly.